Description

A high quality research requires modern, adequately equipped, experimentation facilities. In order to align the Romanian research to European standards in aerospace, energy and environment primary fields, COMOTI Romanian Research and Development Institute for Gas Turbines aims to increase the research capabilities and the competitiveness.

The Gas Turbines Experimentation Complex, employed in high scientific researches concerning the testing of last generation aviation gas turbines and the aviation and industrial gas turbines of the future, includes the following major structures:

  • Test cell for turbojets in the 0 – 10,000 daN range, relocated metallic structure;
  • Test cell for turbo-shaft power group in the 0 – 5.2 MW range, steel concrete new structure, under construction (TV2, TA-2, TURMO, TV3);

Test cell for turboprops equipped with propellers, in the 500 – 4,000 kW range, structure of 8,000 mm diameter;
  • Multipurpose structure (command room, liquid fuels room, offices, gas turbines preparation room, metrology shop, storages, lavatory and lockers) with electrical installation of power, general illumination and safety, water and sewage installation, heating and ventilation installation.

The activity of the Gas Turbine Experimentation Complex is of diagnose, monitoring or certification, through test bench testing, for thermo-gas-dynamic researches, new constructive solutions experimentation, gas turbines quality certification. This activity leads to complex installations designed for clients as DISTRIGAZ, OMV PETROM, TERMICA Botoşani for:

  • Gas generators – derived from aviation gas turbines: AI20 GM gas generator which equipped a natural gas turbo-compressor group at STC ONEŞTI;

Free turbine power groups – derived from aviation turboprops, from which the free turbine has been separated: TL 36 power group equipping natural gas compression groups at STC Vinţu de Jos and Siliştea.
  • Turbo-compressor power groups – consisting in free turbine power groups driving one or two compressors: TG 45 power group equipping natural gas compressors at STC Băţanii Mari and GTC 1000 natural gas compression group at STC Ţicleni;
  • Cogeneration groups – consisting in transformed aviation gas turbines operating on natural gas and driving, with the help of a gearbox, an electric generator. The burned gases pass through a recovery boiler producing thermal energy as hot water or technologic steam: GTE 2000 cogeneration group.

    Technical equipments

    The CExT’s technical equipments, comparable to similar installations used by renowned entities in the gas turbines field, embodied in specific technological facilities, adapted for a wide range of types of gas turbines:

    • Installations of lubrication and cooling, of natural gas and liquid fuels feeding, of load dissipation (hydraulic, gas-dynamic, thermo-gas-dynamic and electric brakes), of instrumental air, of pneumatic and electric start, of fuel dosage, specific couplings, electric power installations, silencers, oil/air separators, separator vessel filter, natural gas compression installation with integrated command system; gearbox components, compressor case and multiplier case;

    Last generation command and control consoles with instrumentation systems for parameters’ acquisition, alarm and protection, gas detection; Programmable Logic Controller (PLC) with 80 analog inputs, 8 analog outputs, 64 digital inputs and 64 digital outputs for improved data acquisition (accuracy and acquisition speed);

    Modern data acquisition system consisting in data processing equipment and pressures measurement equipment. These modular systems include the necessary elements for the acquisition and the processing of all signal types. The sampling rates of the electronic system are 500 kHz, representing the current top in the field of transient regimes field.

    Modern data acquisition system consisting in data processing equipment and pressures measurement equipment. These modular systems include the necessary elements for the acquisition and the processing of all signal types. The sampling rates of the electronic system are 500 kHz, representing the current top in the field of transient regimes field.

    The supplied equipment is purchased from the renowned companies in the aviation field and is approved by most of the gas turbines manufactures worldwide. These equipments needed testing, overhauling and repairs, bringing up to date, new adjustments for higher performance in order to meet new demands. Due to testing/certifying technologies evolution and rejuvenation, a data acquisition system; data processing and performance compilers are used for high precision results. Using verification methods – such as vibes determination software, spectral analysis and other processing – a series of problems can be solved, such as mass unbalance compensations, reliability and life span estimation, wear degree, which contribute to an adequate overhauling and repairs program design.

    One of the current issues of high importance is the environment protection. Like other organisations involved in economical and industrial activities, the Gas Turbine Experimentation Complex will also explicitly implement the environment protection policy by endowing and incorporating new and efficient phonic and chemical environmental pollution reduction equipments. Equipments like: noise suppressors and air/oil separators (oil recovery efficiency from resulted vapours during functioning is of 95%), will be placed in experimentation areas, as well as, incorporated in the products delivered to beneficiary.

    Beneficiaries

    Based on its equipments, CExT was, and can be used by a variety of entities interested in performing research – development – innovation – manufacturing activities. CExT is available for carrying out research, testing, experimentation and laboratory educational activities in the field of turbojets, turboprops, turbo shafts and micro gas turbines, for all research and higher education institutions in Romania, as well as for interested companies from abroad. COMOTI provides the required experimental support for young professionals in training in elaborating diploma and PhD projects. In this context, COMOTI collaborates with the Faculty of Aerospace Engineering, Faculty of Material Science and Engineering of the University Politehnica of Bucharest and Military Technical Academy. COMOTI can provide to the entities specialized in aviation, TURBOMECANICA Bucureşti, TAROM, ROMAVIA, IAR Ghimbav and AEROSTAR Bacău, the Gas Turbine Experimentation Complex for performing tests / experimentation.

    So far, COMOTI has performed research activities for developing power groups in the power range of 0.7 – 2.5 MW, using aeroderivative or industrial gas turbines and being the only R&D Romanian entity with practical results in this field. The gas turbines power groups have been tested in the experimentation complex and then valorised in technical – economical applications. Economical users that will further on benefit from the CExT services are the big companies which are equipped with turbo-compressor and cogeneration groups: DISTRIGAZ, OMV PETROM SA, TERMICA Botoşani and TRANSGAZ.

    In the last year, in the CExT were performed activities for several R&D national projects:

    In the framework of the National Research, Development and Innovation Plan (PNCDI II):

    • SOTLURB, The project aimed to the valorisation of biogas by using it in aeroderivative gas turbines. In this project, COMOTI has developed an installation for simulating the biogas by mixing, in optimal proportions, of natural gas and CO2, and tested, in CExT, the TV2 gas turbine modified to operate on biogas.

    SICOGEN, Integrated gas turbine-afterburner system to decrease NOx emissions and increase the efficiency of cogeneration plants working on gas fuels;
  • MEMCEN, Modern ways to reduce the pollution and to increase the efficiency of gas turbine cogeneration plants and turbo-compressors for natural gas.
  • In the framework of NUCLEU Programme, Excellence, Practical and Experimental Research in the field of bladed machineries, contribution to the convergence with the EU Research Area in 2010, during 2009 and 2011, COMOTI has carried out 14 projects by means of CExT.

    Through its testing capabilities in a wide range of gas turbines, CExT has extensive offerings and, especially, at attractive prices for the European market. A good example of alignment with international requirements is the contribution of CExT in the last three years to major international infrastructure projects: